Custom Logo Vinyl Transfers | Single Layer Graphic

Upload your logo, artwork or custom design and create durable permanent vinyl transfers for business branding, promotional products and more.

Ideal for adding your branding to products, packaging, signage and other smooth surfaces. Simply upload your design and we’ll create your vinyl transfer ready to apply.

Ready-to-cut artwork: no additional charge
Artwork requiring minor preparation: £5
Complex artwork/redrawing: quoted separately

How to Order

1. Choose your size
Select the transfer size you require from the available options.

2. Upload your design
Upload your logo or single-layer graphic. Your design should be suitable for cutting from one colour of permanent vinyl.

3. Place your order
Complete your order and we’ll prepare your custom vinyl transfer to your chosen size.

4. We create your transfer
Your design will be cut from permanent vinyl, weeded and supplied on application tape, ready to apply.

How to Apply

1. Prepare the surface
Ensure the surface is clean, dry, smooth and free from dust, grease and residue. Allow it to dry completely.

2. Position your transfer
Place the transfer onto the surface and check the positioning before applying.

3. Apply firmly
Use a squeegee, scraper or similar flat tool to firmly rub over the entire design, paying particular attention to the edges and smaller details.

4. Remove the backing
Slowly peel away the backing paper, keeping the transfer close to the surface. If any part of the design lifts, lay the backing back down and rub firmly over the area before continuing.

5. Remove the application tape
Carefully peel away the application tape at a low angle, leaving your vinyl design adhered to the surface.

6. Finish the application
Press over the design once more to ensure all edges and details are firmly adhered.

Important: Allow the vinyl to fully bond before washing, handling or exposing the item to moisture. Application results depend on the surface, preparation and application technique.

Please note: This listing is for single-layer graphic designs. Multi-colour or more complex designs may require a different vinyl application method and should be discussed before ordering.

How to Apply

1. Prepare the surface
Apply to a clean, dry, smooth and grease-free surface. Clean thoroughly and allow to dry completely before application.

2. Position your transfer
Place the transfer onto the surface and check the positioning before applying.

3. Apply firmly
Use a squeegee, scraper or similar flat tool to firmly rub over the entire design, paying particular attention to the edges and smaller details.

4. Remove the backing
Slowly peel away the transfer backing, keeping it close to the surface. If any part of the design lifts, lower the backing again and rub firmly over the area before continuing.

5. Press down the design
Once the backing has been removed, press over the design again to ensure all areas are firmly adhered.

Important: Allow the vinyl to bond fully before washing, handling or exposing the item to moisture. Application results can vary depending on the surface and preparation.